NOTE: During this installation, we will be removing the headlight assembly. If you are replacing the fog light due to damage or wear, it might be a good idea to replace the headlight, as well. After all, it won't be any easier than it is right now!
Step 1: Using the flathead screwdriver, gently pry the silver "crossbar" from the front of the vehicle.
Step 2: Open the vehicle's hood.
Step 3: Loosen and remove the two 8mm bolts located on top of the headlight assembly.
Step 4: Loosen and remove the 10mm retaining bolt located near the inner/bottom of the headlight assembly.
Step 5: Lift on the retaining tab, and pull the assembly from the vehicle. Disconnect the wiring harnesses from the back of the headlight.
Step 6: Disconnect the wiring harness attached to the fog light assembly.
Step 7: Using a flathead screwdriver, gently depress the retaining clips (from the front of the vehicle), while pulling back on the assembly. You will feel it release.
Step 8: You can now remove the fog light assembly.
Step 9: Insert the fog light into the bumper cover. You will feel the clip "snap" into place.
Step 10: Connect the wiring harness to the back of the fog light assembly.
Step 11: Reconnect the head light's wiring harness, and mount the assembly by tightening the 8mm and 10mm bolts.
Step 12: Gently snap the "crossbar" back into place across the front grille.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: