Step 1: Using the needle-nose pliers, remove the 2 retaining pins located in the wheel well.
This allows you to pull back the protective panel, giving you access to the mounting area.
Step 2: From the front of the vehicle, gently wedge your flathead screwdriver into the side of the fog light.
By creating a bit of separation and pushing backwards, the light will release into the interior of the lighting area, allowing you to remove it from the back.
NOTE: Now that the fog light is no longer in place, mark the adjusting screw so you can use it as a reference point for your new fog light. This ensures proper alignment (use a marker).
Step 3: Using the Allen wrench, you can remove the stud.
The Allen wrench bolt is accessible from underneath the casing. There will be a small opening, and you can see the Allen wrench bolt.
Step 4: Disconnect the wiring harness and remove the existing fog light from the vehicle.
Step 5: Connect the wiring harness to your replacement fog light.
Step 6: Be sure that you've aligned the light by moving the adjustment stud to the point that you marked before removing the old one.
Step 7: Insert the new fog light into its opening and mount into place.
It will snap into place.
Step 8: Reattach the inner fender by replacing the pins that hold it in place.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
