This is a simple procedure that simply involves pulling back the wheel well protective cover, exposing retaining screws. Remove them. Also, remove the mounting screws underneath the bumper cover and the screws on top of the grille area. Finally, disengage the two clips that are just beneath the radiator (when facing the vehicle) using a flathead screwdriver
NOTE: If your Corolla is an "S Model", you will need to remove the lower part of the bumper cover by releasing the retaining tabs. This is an easy process, as well!
Step 2: Disengage the retaining clip that holds the fog light assembly in place.
Step 3: You can now remove the fog light assembly.
Step 4: Disconnect the fog light's wiring harness.
Step 5: Connect the wiring harness to the new fog light assembly.
Step 6: Secure the fog light assembly into place by re-engaging the retaining clip.
Step 7: Reattach the front bumper cover by reversing the removal process.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
