Step 1: Release the retaining clips (2) that are located just beneath the PASSENGER'S side windshield wiper (on the exterior of the vehicle).
To release these clips, use a flathead screwdriver to pry the center of the clip UP. You can then pull the rest of the retaining clip from its position.
Step 2: Open the vehicle's hood.
Step 3: Release the retaining clips (3) exposed by opening the hood.
These clips are on the same side as the others, but were covered when the hood was closed.
Step 4: Lift the panel (released by removing the clips), and pull the cabin air filter (1) from the vehicle.
Step 5: Insert the new cabin air filter into the casing.
There are tabs to secure the air filter, so reach into the assembly and be sure that the filter is secured.
NOTE: The guiding arrows on the filter should be pointing UP.
Step 6: Reattach the trim panel by re-engaging the retaining clips (5).
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: