Step 2: Using the flathead screwdriver, remove the clips that secure the tail light assembly to the vehicle.
You can simply pry them loose and pull them from the vehicle. They are exposed by the raising of the rear door and are right beside the tail light assembly.
Step 3: You can now pull the tail light assembly from the vehicle.
Step 4: Disconnect the tail light's wiring harness from the vehicle.
NOTE: If your tail light assembly comes with new bulbs, you can simply disconnect the wiring harnesses from the old assembly and connect them to the new one. However, if not, you will need to use the T25 Torx driver to remove the bulb casings from the old assembly and attach them to the new one. This will only take a few moments!
Step 5: Connect the wiring harness to the back of the new tail light assembly.
Step 6: Secure the new assembly into place by re-engaging the small retaining clips.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
