Step 1: Remove the retaining bolts that hold the front bumper cover in place using the 10mm socket.
You will find one on each side in the tire well. Two more (one per side) are exposed by pulling the inner tire well panel back. Two more are found on each side underneath the front end of the vehicle. On top of the grille, you will find 4 screws.
Step 2: Using the flathead screwdriver, remove the 2 retainers found under the front end of the bumper cover.
Step 3: Disconnect the retaining clips and pull the front bumper cover from the vehicle.
Step 4: Remove the three 10mm retaining bolts (two on top, one underneath the assembly).
Step 5: Disconnect the wiring harnesses found on the back of the headlight assembly.
Step 6: Remove the "marker light" socket found on the outside portion of the assembly.
Step 7: Remove the headlight assembly from the vehicle.
NOTE: If you purchased your replacement headlight from Go-Part.com, your new assembly should have new bulbs included. This will save you steps in the replacement process.
Step 8: Reconnect the wiring harnesses and marker bulb socket to the new headlight assembly.
Step 9: Position the headlight into place and secure it by tightening the 10mm retaining bolts.
Step 10: Reattach the front bumper cover by reversing the removal process.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
