Step 2: Pry and remove the small trim panel that covers the side mirror's mounting point.
Step 3: Loosen and remove the Phillips screws (3).
Two are inside the interior door pull, while the third is just below the speaker.
Step 4: Pry and remove the retaining clips (2) near the latch of the door.
To disengage the clips, remove the center and pry the clip from the door panel.
Step 5: Pry and remove the automatic door lock switch. Disconnect the wiring harness attached to the back.
Step 6: Pry and remove the mirror control switch. Disconnect the wiring harness attached to the back.
Step 7: Pry and lift the window control switch-panel, disconnect the wiring harnesses (2) attached to the underside of the panel.
Step 8: Pry and remove the interior door panel.
A series of clips line the inside of the door panel. Pry along the outer edge to release the panel from the door frame.
Step 9: To reattach the interior door panel, move the panel back into position, and using a FIRM, but not too firm, strike near each retaining clip, “pop†them back into place.
Step 10: Connect the wiring harnesses (2) to the UNDERSIDE of the power window switch, and “snap†the panel back into place.
Step 11: Connect the wiring harness (1) to the back of the power lock switch. Snap the switch back into place.
Step 12: Connect the wiring harness (1) to the back of the power mirror switch. Snap the switch back into place.
Step 13: Tighten the Phillips screws (3). Reattach the trim panel near the side mirror mount.
Step 14: Re-engage the retaining clips (2) near the door latch.
These Part Change / Installation Instructions Apply to
07 2007, 06 2006, 05 2005, 04 2004, 03 2003 Saturn Ion Front Door Panel (Interior) Replacement Instructions
