Step 2: Using the flathead screwdriver, gently pry up the window control switch-panel. Disconnect the wiring harnesses attached to the underside of the panel. Fully remove the panel.
Step 3: Using the small screwdriver, depress the tabs on the interior of the door handle trim panel. Remove this panel.
Step 4: Loosen and remove the two 10mm bolts located near the interior door pull.
Step 5: Gently remove the interior door panel by working your way around it, and pulling outward to disengage the retaining clips.
Step 6: Remove the interior door panel.
Step 7: Remove the insulation that is inside the side mirror's mounting area.
Step 8: Disconnect the side mirror's wiring harness.
Step 9: Loosen and remove the three 10mm retaining bolts that hold the mirror to the door frame.
NOTE: Be sure to hold onto the side mirror while loosening the retaining bolts, as you likely don't want to sweep broken glass from your garage floor or driveway!
Step 10: Feed the wiring harness through the door frame, and mount the mirror by tightening the 10mm retaining bolts.
Step 11: Connect the mirror's wiring harness. Be sure to reattach it to the door with its clip!
Step 12: Reattach the interior door panel.
Simply reverse the removal process.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
