Step 2: Lift the retaining tabs located on the top of the headlight assembly.
Step 3: You can now pull the assembly from the vehicle.
Step 4: Disconnect the wiring harness connected to the back of the headlight assembly.
NOTE: If you purchased your replacement headlight assembly from Go-Part.com, it may have the bulbs included, which means that you can save steps and move right to installation!
Step 5: Connect the wiring harness to the back of the new headlight assembly.
Be sure to match the alignment pin to the length of the old headlight assembly. This ensures that your headlight is properly adjusted and aligned.
Step 6: Move the new headlight assembly into place and secure it by moving the retaining clips back to their original position.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: