Step 2: Pry and lift the small trim panel inside the interior door pull. Remove the Phillips screw (1).
Step 3: Pry and remove the small trim panel inside the interior door handle. Remove the Phillips screw (1).
Step 4: Loosen and remove the Phillips screws (4) that line the bottom and side of the interior door panel.
Step 5: Pry and remove the small trim panel that covers the side mirror's mounting area.
Step 6: Using the door panel clip tool (or putty knife), pry and remove the interior door panel.
A series of retaining clips hold the interior door panel to the frame. You will hear them "pop" as they disengage.
Step 7: Disconnect the locking rod from the back of the interior door panel. Also, disconnect the wiring harnesses to fully remove the panel.
Step 8: Disconnect the side mirror's wiring harness.
Step 9: Loosen and remove the 8mm mounting bolts (3) that hold the side mirror to the vehicle.
NOTE: Be sure to hold onto the side mirror while removing these bolts, as you don't want to sweep broken glass from your garage floor or driveway!
Step 10: Mount the new side mirror by tightening the 8mm bolts (3).
Step 11: Connect the side mirror's wiring harness.
Step 12: Reattach the interior door panel.
Be sure to reconnect all wiring harnesses, tighten any retaining screws, reattach the trim panels, and re-engage the clips that hold the panel to the door frame!
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
