Step 2: Remove the two 7mm retaining bolts located on the top of the headlight assembly.
Step 3: Using the flathead screwdriver, remove the retaining clips located just above the grille area.
This gives you enough room to maneuver the light out of the vehicle chassis.
Step 4: Pull the headlight assembly from the vehicle.
Step 5: Disconnect the wiring harnesses on the back of the headlight assembly.
NOTE: If you ordered your replacement headlight assembly from Go-Part.com, it likely includes new bulbs (as many of our models do)! This allows you to move directly to the installation steps. If not, you can easily twist the bulb sockets to remove them from the old headlight assembly.
Step 6: Connect the wiring harnesses to the back of the new headlight assembly and insert into the chassis.
Step 7: Secure the new headlight assembly by replacing the mounting clips just above the grille area and tightening the 7mm retaining bolts that hold it in place.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
