Step 1: Beneath the glove compartment on the passenger's side, remove the two 5/8 nuts that hold the panel in place. Remove the panel.
Step 2: Disconnect the blower motor's wiring harness.
Step 3: Loosen and remove the three 8mm retaining bolts that hold the blower motor in place.
Step 4: You can now pull the blower motor from the vehicle.
Step 5: Insert the blower motor into place, using the triangular edge as your guide.
Step 6: Tighten the three 8mm retaining bolts to secure the component.
Step 7: Connect the blower motor's wiring harness.
Step 8: Reattach the trim panel that covers the area by tightening the two 5/8 bolts.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
