Step 1: Loosen and remove the 4 Phillips retaining screws that hold the tail light assembly in place.
These screws are located along the outer edge of the tail light assembly.
Step 2: You can now pull the tail light assembly from the vehicle.
Step 3: Disconnect the tail light's wiring harness.
Step 4: Using the flathead screwdriver, pry the small retaining clips that are still in the vehicle' chassis.
These clips are often included with the new tail light assembly. We will have to remove the old ones, as ours will snap into place during installation.
Step 5: Connect the wiring harness to the new tail light assembly.
Step 6: Snap the tail light assembly into place. You will hear the clips "snap" into place.
Step 7: Tighten the 4 Phillips retaining screws to secure the tail light.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
