Step 1: Loosen the three 8mm bolts that hold the fog light assembly in place.
One is on the bottom of the assembly and will require a 1" extension. The other two bolts are located on the top of the assembly.
Step 2: With the bolts removed, use the flathead screwdriver to release the retaining pins that hold the mount casing to the fog light.
Step 3: Using the screwdriver, remove the adjusting screw. Remove the mount casing.
Step 4: Disconnect the wiring harness from the back of the fog light assembly.
Step 5: Assemble the mounting bracket and fog light assembly AFTER you have put both parts "inside" the mounting area (otherwise, they won't fit).
Step 6: Attach the fog light assembly to the mounting bracket.
Step 7: Connect the wiring harness to the fog light, and mount it by tightening the three 8mm bolts.
NOTE: Lengthen or shorten the alignment stud to match that of the old assembly. This ensures proper beam alignment.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: