Step 2: Lift the 2 retaining tabs that hold the headlight assembly in place.
These tabs are located on the back end of the assembly, and accessible from the top.
Step 3: Loosen and remove the 8mm bolt located near the radiator.
Step 4: You can now pull the headlight from the vehicle.
Step 5: Disconnect the headlight assembly's wiring harness.
NOTE: If you ordered your replacement headlight from Go-Part.com, it likely includes new bulbs, as most of our models do. This saves you an installation step! However, if your particular model does not, simply transfer the bulbs and sockets to the new assembly. This process takes just a few moments! Also, you can transfer the wiring harness using a Phillips screwdriver, if necessary.
Step 6: Connect the wiring harness to the new headlight assembly.
Step 7: Move the assembly into position, and secure it with the retaining tabs.
Step 8: Tighten the 8mm retaining bolt.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
