NOTE: During this installation, we will be removing the headlight assembly. If you are replacing the turn signal assembly due to damage or wear, it may be a good idea to replace the headlight, as well. After all, it will never be easier than it is right now!
Step 1: Open the vehicle's hood.
Step 2: Loosen and remove the two 10mm mounting bolts located on top of the headlight assembly.
Step 3: You can now pull the headlight assembly from the vehicle.
Step 4: Disconnect the wiring harness from the back of the headlight assembly.
Step 5: Disconnect the wiring harness from the back of the turn signal assembly.
Step 6: Loosen and remove the two 8mm mounting bolts that hold the assembly in place.
Step 7: You can now pull the turn signal assembly (from the back) from the vehicle.
Step 8: Move the new turn signal assembly into place, and secure it by tightening the two 8mm mounting bolts.
Step 9: Connect the wiring harness to the new turn signal assembly.
Step 10: Reconnect the headlight's wiring harness, and mount it by tightening the two 10mm mounting bolts.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
