Step 1: From the front of the vehicle, reach into the lower grille and disengage the fog light's retaining arm.
This arm looks like a "sideways U". You can simply use your finger to push it away from the fog light assembly and it will "snap" back.
Step 2: You can now pull the fog light assembly from the vehicle.
Step 3: Disconnect the wiring harness from the back of the fog light assembly.
NOTE: Some models may not utilize the wiring harness. IF this is the case, simply turn the socket counter-clockwise and pull the bulb/socket from the assembly.
Step 4: Remove the locking mechanism (sideways U) from the vehicle, and attach it to the new fog light assembly.
Measure the alignment screw located on the side of the locking mechanism. Use the T20 Torx driver to remove the screw, and attach it to the new assembly. You can now add the spring and locking mechanism. Be sure that the screw length matches that of the old assembly, as this ensures proper alignment!
Step 5: Connect the wiring harness to the new fog light assembly and move the entire component into position.
Step 6: Re-engage the mounting mechanism to finalize the project.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
