NOTE: In this project, we'll be removing the headlight assembly to access the side marker light. If you are replacing the marker light due to damage or wear, you may want to replace the headlight assembly, as well. You'll already be removing it, and it will never be easier than it is right now!
Step 1: Open the vehicle's hood.
Step 2: Loosen and remove the two 10mm mounting bolts located above the headlight assembly.
Step 3: Disconnect the headlight's wiring harness, and remove the headlight assembly from the vehicle.
Step 4: Disengage the clips that hold the side marker in place, and push it (from behind) out from its position in the bumper cover.
Step 5: Disconnect the wiring harness attached to the side marker light.
Step 6: Connect the wiring harness to the new side marker light and insert it into the bumper cover.
You will feel and hear the clips "snap" into position.
Step 7: Reconnect the headlight assembly's wiring harness, and mount it by tightening the 10mm mounting bolts.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
