Step 1: Remove the panel protecting the mounting components for the side view mirror.
You'll also want to protect and remove the tweeter. Use the towel to protect the plastic!
Step 2: Using the flathead screwdriver, pop the window control panel loose.
Step 3: Disconnect the wiring harness from the window control panel.
Step 4: Using the Phillips screwdriver, remove the 4 screws that hold the panels in place.
You'll find one by the door handle, one beneath the window control panel, one near the front of the door-mounted arm rest, and one near the interior door reflector (near the bottom).
Step 5: Using the putty knife, feed it into the bottom of the panel, where the door meets the panel.
Step 6: Slide the putty knife along until you reach a clip, and detach it.
Repeat this step to detach all of the clips holding the door panel in place.
Step 7: Remove the door panel.
Step 8: Disconnect the wiring switch on the back of the door panel.
Step 9: Reconnect the wiring switch on the back of the door panel.
Step 10: Begin connecting the door panel to the door (top first).
Step 11: Reconnect the small speaker.
Step 12: Snap all of the retaining clips into place.
Double check them to make sure that they are secure.
Step 13: Replace the door handle, and all Phillips screws.
Step 14: Reconnect the window control panel and snap it into place.
These Part Change / Installation Instructions Apply to
06 2006, 05 2005, 04 2004, 03 2003, 02 2002, 01 2001, 00 2000, 99 1999 Pontiac Grand Am Door Panel Replacement Instructions
