Step 1: Lift the hood and depress the tab that releases the front grille.
Use the screwdriver to depress the tab. Once the clip near the radiator cap has been released, you can remove the grille.
Step 2: Locate five Torx 27 screws on the top of the front bumper cover and the two bolts that are behind the small, removable panels on the underside of the bumper cover. Remove them.
Step 3: Remove the four Torx 20 bolts on each side to completely remove the bumper cover.
Step 4: Disconnect the parking light from each side of the bumper cover.
Step 5: Remove the four T20 screws that hold the headlight assembly in place.
Two on the top, and two on the bottom.
Step 6: Remove the headlight assembly from the vehicle.
Step 7: Disconnect the electrical harness from the back of the assembly.
NOTE: If you purchased your replacement headlight from Go-Part.com, you may not need to remove the bulbs, as they are already included. This can save you steps!
Step 8: Connect the electrical harness to the new headlight assembly.
Step 9: Secure the new assembly by tightening the T20 screws.
Step 10: Put the bumper cover back on by reversing the removal process.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
