Step 2: Pry and remove the window control switch-plate. Disconnect the wiring harnesses (4) attached to the underside of the panel.
Step 3: Loosen and remove the Phillips screw (1) located inside the interior door handle. Once removed, pry and remove the entire bezel panel.
Step 4: Loosen and remove the 7mm bolts (2) that are just behind the interior door pull.
Step 5: Using the door panel clip tool (or putty knife), pry and remove the interior door panel.
A series of small retaining clips hold the door panel to the vehicle. You will hear them "pop" as they disengage.
Step 6: You can now lift and remove the interior door panel.
Step 7: Remove the screw covers (3) near the side mirror mounting area.
Step 8: Disconnect the side mirror's wiring harness.
Step 9: Loosen and remove the 10mm mounting bolts (3) that secure the side mirror to the vehicle.
NOTE: Be sure to hold onto the side mirror while removing the 10mm bolts, as you don't want to sweep broken glass from your garage floor or driveway!
Step 10: You can now remove the side mirror.
Step 11: Feed the wiring through the opening in the door frame, and mount the mirror by tightening the 10mm mounting bolts (3). Cover the bolts with the covers (3).
Step 12: Connect the side mirror's wiring harness.
Step 13: Reattach the interior door panel.
Simply reverse the removal process. Be sure to reconnect all wiring harnesses, tighten the 7mm bolts, and re-engage the retaining clips attached to the back of the door panel!
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: