Step 1: Disconnect the negative battery cable using the 8mm wrench.
Step 2: Open the vehicle's door.
Step 3: Pry and remove the small trim panel beneath the interior door pull. Remove the Phillips screws (2) behind the trim panel.
Step 4: Pry and remove the small trim panel that covers the side mirror's mounting area. Disconnect the speaker's wiring harness, if necessary.
Step 5: Pry and remove the small door reflector. Loosen and remove the Phillips screw (1) behind the reflector.
Step 6: Using the door panel clip tool (or putty knife), pry and remove the interior door panel.
A series of clips hold the interior door panel to the door frame. You will feel them "pop" as they disengage.
Step 7: You can now remove the interior door panel. Disconnect the wiring harnesses from the back of the interior door panel.
Step 8: Disconnect the side mirror's wiring harness.
Step 9: Remove the insulation from the mirror's mounting area. Remove the 10mm mounting bolts (3).
NOTE: Be sure to hold onto the mirror while removing these bolts, as you don't want to sweep broken glass from your garage floor or driveway!
Step 10: Mount the new side mirror by tightening the 10mm bolts (3).
Step 11: Connect the mirror's wiring harness.
Step 12: Reattach the interior door panel.
Simply reverse the removal process. Be sure to reconnect all wiring harnesses, tighten the Phillips screws, and reattach any trim panels we removed!
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: