Step 1: Beneath the glove compartment on the passenger's side, loosen and remove the 7mm bolts (4) that secure the panel to the underside of the dashboard.
One of these bolts is near the gas pedal.
Step 2: You can now remove this panel.
Step 3: Loosen and remove the 7/32 bolt (1) that holds the thin cover panel over the air filters.
Step 4: You can now pull the air filters (2) down and out of the assembly.
NOTE: Expect plenty of dust and dirt, as the component has been doing its job well! Be sure that you have a vacuum handy! The filter died a noble death!
Step 5: Using the guiding arrows on the filters for reference, slide the new filters (2) into place.
The arrows should point toward the DRIVER'S side of the vehicle.
Step 6: Tighten the 7/32 bolt to secure the air filter's cover to the assembly.
Step 7: Tighten the 7mm bolts (4) to secure the dash's UNDER panel to the dash.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
These Part Change / Installation Instructions Apply to
02 2002, 01 2001, 00 2000, 99 1999 Chevrolet Silverado, Suburban, Sierra, Yukon Cabin Air Filter Instructions
