NOTE: If you are replacing your blinker/parking light assembly due to wear or damage, you may want to replace the headlight assembly, as well. You will be removing it, and it will never be easier than it is during this project!
Step 1: Pull up on the two retaining tabs located just behind the headlight assembly.
Step 2: Disconnect the wiring harnesses from the back of the headlight assembly and remove it from the vehicle.
Step 3: Depress the retaining tabs located to each side of the assembly and pull it from the vehicle.
Step 4: Disconnect the wiring harness on the back of the parking light/blinker assembly.
NOTE: If your new parking light/blinker assembly includes bulbs, you can simply connect the wiring harness and install it. However, if it doesn't, simply turn the socket counter-clockwise to remove it from the old assembly and insert it into the new one.
Step 5: Connect the wiring harness to the new parking light assembly.
Step 6: Secure the new parking light by re-engaging the two retaining clips.
Use the tabs on the back of the assembly as your guides. You will some of them snap into place, while others act simply as your guides.
Step 7: Reattach the headlight assembly by reconnecting the wiring harnesses and securing it by re-engaging the retaining tabs.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
