Step 1: Loosen and remove the Phillips screw located just above the headlight assembly.
Step 2: With a firm tug, you can pull the turn signal assembly from the vehicle.
Step 3: Disconnect the wiring harness from the turn signal assembly.
NOTE: If you are replacing your turn signal due to collision damage, it may be a good idea to replace the headlight assembly, as well. The second project only requires the removal of a few more bolts, and it will never be easier than it is right now!
Step 4: Connect the wiring harness to the new turn signal assembly.
Step 5: Using the guiding tabs, insert the assembly into place, and secure it by tightening the Phillips screw.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
