Step 2: Pry and life the power window control panel. Loosen and remove the Phillips screws (2) on the UNDERSIDE of the panel, and disconnect the wiring harness (1).
Step 3: Pry and remove the interior door handle's bezel.
Step 4: Pry and remove the screw covers (2) on the interior door pull. Loosen and remove the Phillips screw (1).
Step 5: Loosen and remove the Phillips screw (1) exposed by removing the power window control panel.
Step 6: Loosen and remove the Phillips screw (1) on the BOTTOM edge of the interior door panel.
Step 7: You can now LIFT and remove the interior door panel from the door frame.
Step 8: To reattach the interior door panel, slide the panel OVER the locking lever and onto the door frame.
NOTE: Be sure that you feed the wiring harness through the opening in the door.
Step 9: Tighten the Phillips screws (4).
The shorter screws are for the door pull!
Step 10: Reattach the screw covers (2), and the interior door handle's bezel.
Step 11: Reconnect the wiring harness (1), tighten the Phillips screws (2), and snap the power window control panel back into place.
These Part Change / Installation Instructions Apply to
02 2002, 01 2001, 00 2000, 99 1999, 98 1998 Mercury Grand Marquis Rear Door Panel (Interior) Replacement Instructions
