Step 2: Remove the 8mm bolt that mounts the wiper fluid reservoir.
Step 3: Slide the wiper fluid reservoir to the side, as we'll need the room to access the blower motor.
Step 4: Disconnect the rubber tube connected to the blower motor.
Step 5: Disconnect the wiring harness attached to the blower motor.
Step 6: Locate and remove the three 8mm retaining bolts that hold the blower motor in place.
NOTE: You may need to loosen the wheel well panel beneath it to get enough "play" to push down on the upper portion of the fender. This is sometimes necessary to reach the retaining bolt on the underside of the component.
Step 7: You can now pull the blower motor from the vehicle.
Step 8: Remove the blower motor's house and attach it to the new blower motor.
Step 9: Insert the blower motor into place, and secure it by tightening the 8mm retaining bolts.
If you loosened the wheel well panel, be sure to secure it, as well.
Step 10: Connect the rubber hose and wiring harness to the blower motor.
Step 11: Secure the wiper fluid reservoir in place by tightening its retaining bolt.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
These Part Change / Installation Instructions Apply to
02 2002, 01 2001, 00 2000, 99 1999, 98 1998 Lincoln Town Car AC Heater Blower Motor Replacement Instructions
