Step 2: Pry and remove the small cover inside the interior door handle, exposing a Phillips screw (1). Loosen and remove this screw.
Step 3: Push the door handle toward the HINGE side of the door and remove it from the vehicle.
Step 4: Disengage the locking rod from the back of the door handle (using the clasping mechanism).
Step 5: Disconnect the wiring harness from the back of the interior door handle.
Step 6: Loosen and remove the Phillips screws (2) that hold the power lock mechanism to the interior door handle assembly.
Step 7: Attach the power lock mechanism to the new interior door handle.
Step 8: Connect the wiring harness to the new interior door handle, and re-engage the locking rod retaining clip.
Step 9: Slide the interior door handle into position, and secure it by tightening the Phillips screw (1).
Step 10: Reattach the small panel that covers the Phillips screw.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
These Part Change / Installation Instructions Apply to
02 2002, 01 2001, 00 2000, 99 1999, 98 1998 Honda Accord Interior Door Handle Replacement Instructions