Locate the 8mm and 10mm bolts in the tire well on each side. Remove them and disengage the clips found on the upper and lower attachment points of the bumper cover. The clips can be disengaged using a flathead screwdriver.
Step 2: Using the 10mm socket, remove the four bolts that hold the headlight assembly in place.
Two will be found on top of the assembly, and the other two will be underneath it.
Step 3: Disconnect the wiring harness on the back of the headlight assembly.
NOTE: If you ordered your replacement headlight assembly from Go-Part.com, it may include new bulbs, which can save you steps in the installation process. You DO NOT need to unscrew the sockets from the back of the assembly. Instead, simply disconnect the harnesses.
Step 4: Remove the headlight assembly and unscrew the parking light socket.
Step 5: Connect the wiring harnesses to the new headlight assembly and screw the parking light into the unit.
Step 6: Secure the assembly by tightening the four 10mm bolts into place.
Step 7: Reattach the front bumper cover by reversing the removal process.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
