Step 1: Open the passenger's side door and remove the fuse panel.
Step 2: Loosen and remove the Phillips screws (2) that secure the bottom panel in place.
Step 3: Remove the panel beneath the glove compartment.
Step 4: Loosen and remove the Phillips screws (3) that line the metal panel (beneath the glove compartment).
Step 5: Open the glove compartment, remove the screw covers (2), and remove the Phillips screws (3).
Two are behind the screw covers, while the third is in the center/top.
Step 6: You can now pull the glove compartment from the vehicle. Disconnect the wiring harness (1) from the glove compartment light.
Step 7: Disengage the tabs (2) that hold the air filter compartment door in place. Pull this door through the BOTTOM of the compartment.
Step 8: You can now pull the filters (2) from the assembly.
Step 9: Insert the new filters (2).
Use the guiding arrows to ensure proper placement. The arrow will point toward the DRIVER'S side.
Step 10: Reattach the assembly cover.
Step 11: Reattach the glove compartment by tightening the Phillips screws (3) and replacing the screw covers (2).
Step 12: Tighten the Phillips screws (3) on the underside of the glove compartment.
Step 13: Reattach the panel beneath the glove compartment, tighten the Phillips screws (2) inside the fuse compartment, and cover the area by reattaching the fuse cover.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: