Phillips screwdriver/Torx driver for headlight alignment
Step 1: Lift the vehicle's hood.
Step 2: Remove the two 6.5mm bolts on the top of the headlight assembly.
Step 3: You can now lift and remove the headlight assembly from the vehicle.
Step 4: Disconnect the wiring harnesses on the back of the headlight assembly.
NOTE: If you ordered your replacement headlight from Go-Part.com, it likely includes new bulbs and sockets, as most of our models do. However, in case it doesn't, simply turn the sockets counter-clockwise to remove them from the old assembly and add them to the new one.
Step 5: Adjust the two adjustor rods that protrude from the back of the assembly.
We recommend measuring the distance of the adjustors on the old headlight assembly and getting the new adjustors as close to that length as possible.
Step 6: Connect the wiring harnesses to the back of the new headlight assembly.
Step 7: Mount the new headlight assembly by using the guiding pins for position and tightening the two 6.5mm retaining bolts into place.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
