Step 1: Remove the two 10mm bolts that hold the fuse box in place over the headlight assembly.
Step 2: Using the 10mm socket, remove the upper bolts to remove the front bumper cover.
Step 3: Using the screwdriver, remove the screws that secure the front bumper cover.
Step 4: Locate the 10mm bolts in the wheel wells and underside of the bumper cover and remove them.
Step 5: Remove the clips found near the radiator to complete the removal of the bumper cover.
Step 6: Remove the front bumper cover from the vehicle.
Step 7: Using the Phillips screwdriver, remove the parking light.
The screw is located on top of the casing. Using your flathead screwdriver, pry the parking light gently away from the vehicle. It will now pop out. Once it does, disconnect the wiring harness.
Step 8: Using the socket, remove the bolt found beneath the parking light.
Step 9: Remove the bolts on the top and side of the headlight to completely remove it from the vehicle.
Step 10: Disconnect the wiring harness from the old assembly.
Step 11: Locate the two adjustment mechanisms on each side of the assembly. Using the Phillips screwdriver, lengthen or shorten the adjustors to approximately the same length on the original assembly.
This ensures that the lights are aligned when used.
Step 12: Connect the wiring harness to the new headlight assembly.
Step 13: Bolt the assembly into place, and replace the parking light.
Step 14: Reattach the bumper using the reverse of the removal process.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
