Step 2: Loosen and remove the Phillips screws (5) that hold the interior door panel to the frame.
These screws are located as follows: (2) on the bottom edge, (1) near the side mirror, (1) near the door pull, and (1) inside the interior door handle.
Step 3: You can now lift and remove the interior door panel.
Step 4: Disconnect the wiring harnesses (2) from the back of the interior door panel.
Step 5: Disengage the door handle's locking rod.
Step 6: Loosen and remove the Phillips screws (3) that hold the power window control panel to the interior door panel.
Step 7: You can now remove the power window switch.
Step 8: Mount the new power window switch by tightening the Phillips screws (3).
Step 9: Reconnect the wiring harnesses and re-engage the locking rod.
NOTE: It's a good idea to TEST the power window switch once connected, just to be sure everything is hooked up properly before reattaching the interior door panel.
Step 10: Reattach the interior door panel by tightening the Phillips screws (5).
These Part Change / Installation Instructions Apply to
00 2000, 99 1999, 98 1998 Dodge Dakota Power Window Switch Replacement Instructions
