Step 2: Loosen and remove the Phillips screw that holds the parking light in place.
This screw is located above the headlight assembly, where the parking light meets the headlight.
Step 3: You can now pull the parking light assembly from the vehicle.
Step 4: Disconnect the wiring harness attached to the back of the parking light.
Step 5: Connect the wiring harness to the new parking light assembly.
Step 6: Position the parking light, and secure it by tightening the Phillips retaining screw.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: