Step 1: Locate and disengage the two clips on top of the headlight assembly.
Step 2: Using the T-20 Torx driver, remove the parking light.
This step may not be necessary, as you can remove the headlight by pulling straight forward.
Step 3: Remove the headlight assembly from the vehicle.
Step 4: Disconnect the wiring harness to completely remove the headlight assembly.
Step 5: Connect the wiring harness to the new headlight assembly.
Adjust the "adjustors" on the new assembly to match the length of those on the old one. This will keep your headlights angled perfectly!
NOTE: If you ordered your replacement headlight from Go-Part.com, it may have all of the bulbs intact. If so, you won't need to remove the bulbs from the old assembly!
Step 6: Insert the new headlight assembly into place.
You will feel it "snap" into place when properly located.
Step 7: Reattach the parking light using the T-20 driver.
Step 8: Reconnect the clips on the top of the headlight assembly.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
