Step 1: Using the flathead screwdriver locate the small clip on top of the parking light, lift it, and remove it.
Step 2: With gentle pressure, pull outward on the parking light assembly.
There are clips holding it in place, so with the flathead screwdriver and a towel to protect the headlight, gently pry it forward.
Step 3: Disconnect the wiring harness from the back of the parking light assembly and fully remove the assembly from the vehicle.
NOTE: If you order your parking light assembly from Go-Part.com, you will receive a full assembly that includes new bulbs. However, if you are only interested in replacing the bulbs, you can easily remove them from the back of the assembly and replace. DO NOT touch the bulbs with your hands!
Step 4: Connect the wiring harness to the back of your new parking light assembly.
Step 5: Snap the parking light assembly into place. Use the tabs as your guides!
Step 6: Reattach the tab on top of the assembly.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
