Step 1: Locate the protective panel that is beneath the glove compartment on the passenger's side of the vehicle.
Step 2: Gently pull on the panel (near the clips) to disengage the retaining clips.
Step 3: With the blower motor now exposed, locate the three 8mm retaining bolts that hold the component in place and remove them.
NOTE: If you do not have an extension, you can remove the glove compartment door quite easily and access them through the opening created.
Step 4: Disconnect the wiring harness from the blower motor.
Step 5: Remove the blower motor from the vehicle.
Step 6: Mount the new blower motor component by tightening the 3 retaining bolts.
NOTE: Be sure to move the wiring harness out of the way, as you'll need to connect it in the next step!
Step 7: Connect the wiring harness to the new blower motor.
Step 8: Reattach the protective panel by simply snapping the small retaining tabs into their respective holes.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: