Step 2: Remove the Phillips screw that holds the parking light in place.
Step 3: You can now pull the parking light from the vehicle. Disconnect its wiring harness.
Step 4: Remove the two 10mm bolts that hold the grille in place. Remove the grille.
Step 5: Remove the three 10mm bolts and the 10mm nut that hold the headlight assembly in place.
One is located in the area exposed by removing the parking light, another is on top of the assembly (near the outer edge of the engine compartment, and the final two bolts are exposed by removing the grille.
Step 6: You can now pull the headlight assembly from the vehicle.
Step 7: Disconnect the wiring harnesses attached to the back of the assembly.
NOTE: If you ordered your replacement headlight from Go-Part.com, it likely includes new bulbs, as most of our models do. This saves you an installation step! However, if your particular model does not, you can easily transfer the bulbs from one assembly to the other. This process takes just a few moments!
Step 8: Connect the wiring harnesses to the new assembly, and mount it by tightening the four 10mm mounting bolts.
Step 9: Reconnect the parking assembly, and secure it by tightening the Phillips screw.
Step 10: Reattach the vehicle's grille by tightening the two 10mm mounting bolts.
NOTE: To align the headlight beam, use the Phillips screw that is on top of the assembly to aim it up or down, and the lever on the back of the assembly to aim it left or right.
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website: