Step 2: Loosen and remove the Phillips screw (1) that holds the side marker assembly in place.
This screw is located just above where the headlight and side marker light assemblies meet.
Step 3: You can now pull and remove the side marker light from the vehicle.
Step 4: Disconnect the wiring harness attached to the back of the marker light assembly.
NOTE: If you ordered your replacement side marker assembly from Go-Part.com, it likely includes a new bulb, as most of our models do. This saves you an installation step! However, if your particular model does not, simply twist the socket counter-clockwise to pull it from the old assembly and attach it to the new one. This process takes just a few moments!
Step 5: Connect the wiring harness to the new side marker light assembly.
Step 6: Mount the new side marker light by tightening the Phillips retaining screw (1).
Use the guiding tabs on the assembly to ensure proper placement and installation.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
