Step 2: Loosen and remove the 4 Phillips screws that hold the tail light assembly in place.
Two are located on the outside of the casing, and the other two are located to the inside.
Step 3: Disconnect the wiring harness that attaches to the back of the tail light assembly, and unscrew the lower light, removing it from the assembly.
NOTE: If you ordered your replacement tail light assembly from Go-Part.com, it likely includes new bulbs, as most of our models do. This saves you an installation step! However, in case your particular model does not include them, simply turn the sockets counter-clockwise to remove them from the old assembly and insert them into the new one.
Step 4: Connect the wiring harness to the back of the new tail light assembly and insert the lower bulb.
Step 5: Secure the new assembly by tightening the 4 Phillips retaining screws.
Use the guiding tabs on the assembly to ensure proper placement.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
