Step 2: Remove the trunk panel that covers the tail light mounting area.
Step 3: Disconnect the wiring harness that attaches to the tail light.
Step 4: Loosen the three 10mm retaining bolts.
Once bolt is inside the trunk (on the back of the tail light), and the remaining two are on the outside of the vehicle (exposed by opening the trunk).
Step 5: You can now pull the tail light assembly from the vehicle.
Step 6: Remove the small trim panel that is attached to the bottom of the tail light assembly.
Step 7: Attach the trim panel to the new tail light assembly.
It should snap into place.
Step 8: Feed the wiring harness through the opening and move the new tail light into place.
Use the guiding pins to ensure proper placement and installation.
Step 9: Tighten the three 10mm retaining bolts and connect the wiring harness.
Step 10: Reattach the trunk liner trim panel.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
