Step 2: Remove the three Phillips screws that hold the grille in place.
Step 3: Disengage the retaining tabs (one on each side of the grille), and remove the grille from the chassis.
Step 4: Remove the Phillips retaining screw on the top of the headlight assembly.
Step 5: Remove the marker light and disconnect the wiring harness.
This is the light assembly next to the headlight assembly.
Step 6: Using the 10mm socket/ratchet/extension, remove the two retaining bolts that are exposed by removing the marker light assembly.
Step 7: Remove the 10mm bolt that is on top of the headlight assembly.
Step 8: You can now pull the headlight assembly from the vehicle.
NOTE: If you ordered your replacement headlight from Go-Part.com, it likely includes new bulbs in the unit (as most of our models do)! If so, you can save time by simply moving on to installation. If not, the bulbs are easily removed by simply turning them counter-clockwise.
Step 9: Disconnect the wiring harnesses from the back of the headlight assembly.
Step 10: Connect the harnesses to the back of the new headlight assembly and move into position.
Step 11: Tighten the new headlight assembly into place by tightening the three 10mm retaining bolts.
Step 12: Reattach the marker light's wiring harness and secure by tightening the Phillips retaining screw.
Step 13: Reattach the grille by reversing the removal process.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
