Step 1: Locate the retaining screw between the marker light and the headlight and remove it.
Step 2: Remove the retaining screw that is located just above the marker light casing.
Step 3: Remove the lower retaining screw that is beneath the marker light.
Step 4: You can now pull the marker light from the vehicle.
Step 5: Behind the marker light, you will find two more retaining screws. Loosen and remove them.
Step 6: You can now pull the turn signal casing from the vehicle.
Step 7: Disconnect the wiring harness on the back of the turn signal assembly.
Step 8: Connect the wiring harness to the back of the new turn signal and put it into place.
Step 9: Secure the turn signal assembly by tightening the two retaining bolts.
Step 10: Secure the marker light, and tighten the retaining screws that hold the assemblies in place.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
These Part Change / Installation Instructions Apply to
97 1997, 96 1996, 95 1995, 94 1994, 93 1993 Jeep Grand Cherokee Turn Signal Replacement Instructions
