Step 2: Loosen and remove the Phillips screws (2) on the OUTER edge of the tail light assembly.
Step 3: Loosen and remove the Phillips screws (2) on the INNER edge of the tail light assembly.
Step 4: You can now pull the tail light assembly from the vehicle.
Step 5: Disconnect the wiring harnesses (2) from the back of the tail light assembly.
NOTE: If you ordered your replacement tail light assembly from Go-Part.com, it likely includes new bulbs and sockets, as most of our models do. However, if your particular model does not, simply twist the sockets COUNTER-CLOCKWISE to remove them from the assembly and insert them into the new one. This process takes just a few moments!
Step 6: Connect the wiring harnesses (2) to the back of the new tail light assembly, and move it into position.
Step 7: Secure the tail light assembly by tightening the Phillips screws (4).
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
