Step 2: Remove the two Phillips retaining screws just to the inside of the tail light assembly.
Step 3: Remove the pins that hold the trunk liner in place and pull it back, exposing the rear of the tail light assembly.
Step 3: You can now remove the tail light assembly from the vehicle.
Step 4: Disconnect the wiring harness to fully remove the assembly.
Step 5: Feed the wiring of the new tail light assembly through the opening, and attach it to the vehicle by tightening the Phillips retaining screws. Connect the wiring harness to the new tail light assembly.
NOTE: If your assembly comes with the mounting bracket, you will want to remove the 8mm retaining bolts that hold the old bracket in place.
Step 6: Tighten the retaining bolts of the new bracket (if necessary).
Step 7: Replace the trunk liner pins and cover the rear of the tail light assembly.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
