Step 2: Using your Phillips screwdriver, remove the parking light's single retaining screw, and remove the parking light from the vehicle.
The retaining screw is located just above the parking light.
Step 3: Remove the vehicle's grille.
Remove the retaining screws/bolts to remove the grille from the vehicle.
Step 4: Remove the four 10mm retaining bolts that secure the headlight assembly in place. Two are located on each side.
Step 5: You can now pull the headlight assembly from the vehicle.
Step 6: Disconnect the wiring harness on the back of the headlight assembly.
Step 7: Attach the wiring harness to the back of the new headlight assembly.
Step 8: Secure the new headlight into place by tightening the four 10mm retaining bolts.
Step 9: Reattach the grille.
Step 10: Reconnect the wiring harness to the back of the parking light and secure into place by tightening the Phillips retaining screw.
Please Note
While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.
And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.
This article pertains to the following products sold on our website:
