How do you Change, Replace, or Install 1979-2010 Ford Crown Victoria AC Heater Blower Motor Replacement

Click here for all of our other replacement guides

Tools required:

8mm socket/ratchet with extension

Step 1: Open the vehicle's hood.

Step 2: Locate the blower motor on the passenger's side of the vehicle near the engine area's firewall.

Step 3: Remove the two 8mm retaining bolts that hold the wiring bundle in place.

These bolts are near the top of the blower motor. You will need an extension for these bolts.

Step 4: Disconnect the wiring harness attached to the blower motor.

Step 5: Now that you can push the wiring bundle out of the way, remove the ratchet's extension and remove the other 8mm retaining bolts. There will be 2 of them.

Step 6: Disconnect the rubber hose from the vehicle's firewall.

Step 7: You can now remove the blower motor from the vehicle.

Step 8: Slide the gasket onto the new blower motor, and begin mounting it to the vehicle.

There are guiding studs on the blower motor. Use them to ensure proper installation.

Step 9: Attach the rubber hose to the vehicle's firewall.

Step 10: Connect the blower motor's wiring harness.

Step 11: Secure the blower motor by tightening the four 8mm retaining bolts.

Tighten the lower bolts first, as the upper bolts will also involve moving the wiring bundle back into position.

Step 12: Be sure that the wiring bundle is properly secured.

Please Note

While we are more than happy to create these installation guides for your benefit, we cannot maintain any liability regarding the part, or the driving experience, once the part has been replaced/installed. We always guarantee the quality of the parts we provide, but the installation liability rests solely on the installer.

And, though we are always here to answer your questions, please note that our technicians created these guides for your convenience, and cannot provide assistance beyond this guide.

This article pertains to the following products sold on our website:

	1980 - 1986 Ford Bronco AC A/C Heater Blower Motor (1W7Z 19805 BA) For Models W/ Factory Installed A/C. High Quality TYC Brand.	$40.95
	1980 - 1986 Ford F-Series Pickup AC A/C Heater Blower Motor (1W7Z 19805 BA) For Models W/ Factory Installed A/C. High Quality TYC Brand.	$40.95
	1979 - 2010 Ford Crown Victoria AC A/C Heater Blower Motor (1W7Z 19805 BA) High Quality TYC Brand.	$40.95
	1979 - 2008 Mercury Grand Marquis AC A/C Heater Blower Motor (1W7Z 19805 BA) High Quality TYC Brand.	$40.95

These Part Change / Installation Instructions Apply to
10 2010, 09 2009, 08 2008, 07 2007, 06 2006, 05 2005, 04 2004, 03 2003, 02 2002, 01 2001, 00 2000, 99 1999, 98 1998, 97 1997, 96 1996, 95 1995, 94 1994, 93 1993, 92 1992, 91 1991, 90 1990, 89 1989, 88 1988, 87 1987, 86 1986, 85 1985, 84 1984, 83 1983, 82 1982, 81 1981, 80 1980, 79 1979 Ford Crown Victoria AC Heater Blower Motor Replacement Instructions

- POPULAR GUIDES: FORD CROWN VICTORIA -

2003-2010 Ford Crown Victoria, Lincoln Town Car, Grand Marquis, Marauder Wiper Switch Replacement

1999-2005 Ford Crown Victoria Tail Light Replacement

1998-2008 Ford Crown Victoria Headlight Replacement

1998-2002 Ford Crown Victoria, Mercury Grand Marquis Rear Door Handle (Exterior) Replacement

1995-2002 Ford Crown Victoria Outer Tie Rod Replacement

1992-2011 Ford Crown Victoria, Mercury Grand Marquis Engine Air Filter Replacement

Your cart is completely and totally empty!